Roof Drain Downspout Connection

A hole at the bottom of the gutter or an open gutter end will just splash water around in a heavy rain.

Roof drain downspout connection.

Don t glue this joint. The flexible design easily bends and holds its shape and can be extended from 25 in. Place an ads downspout adapter on the end of the downspout snap the ads non perforated pipe into the snap coupling end of adapter and run ads non perforated pipe to the disposal area. Debris flowing down the downspout drain leaves from gutters can block floor drains or even the main building sewer line leading to sewage backups into the structure.

Once the tubing is in place cover it with at least 3 in. Slide the angle fitting and a downspout filter together. A 2 inch by 3 inch downspout diameter can handle the water load on a 600 square foot roof. Downspouts are drainage pipes that direct rain water from the roof to the ground.

Hold the pipe and filter end against the downspout so the filter is slightly above ground. Slip the sock over the connection. Ads non perforated pipe carries rainwater away from houses and keeps water from seeping down basement walls and creating wet basement problems. The one thing that pretty much everybody agrees on is that at least there should be a downspout to deliver the water to the lower roof and point it in the right direction.

This piping can be attached to downspouts storm drain inlet street curb and other disposal areas. This is where the rainwater is lead away from the building s foundation so that no rainwater is able to pool around the building. Debris flowing down a downspout drain that has been foolishly connected to the building foundation drain system can block that drain leading to basement flooding from either roof runoff or surface and subsurface runoff or both. Then proceed down the trench to the first turn lay in a 90 degree elbow and cut a length of pipe to fit between it and the assembly at the downspout.

Use a y fitting to make the connection. Use this downspout extension to divert water away from the foundation or connect to drainage pipe and catch basin to control drainage. Mark on the downspout where you need to cut it. Gently insert the downspout adapter and reducer assembly into the pipe protruding from the elbow after slipping the adapter onto the downspout.